When the hot tub is first powered up the control panel will begin a 2 minute Startup Mode. Different codes will display on the screen. Once Startup Mode completes, the actual temperature is displayed on the screen, and the spa will then begin to heat and maintain the water temperature and the first filter cycle will start. Your hot tub has been designed so that it will automatically heat the water to the factory set temperature of 100°F unless you set the spa to a different temperature. If power is disconnected from the spa, it will automatically revert back to the last saved set temperature when power is reapplied.
- Adjust Temperature: The temperature can be adjusted between 80°F - 104°F / 26.5°C - 40°C. Press the Plus or Minus buttons to set your desired temperature. After five seconds, the LCD will display the current spa temperature. The “heater” indicator lights up when the heater is on. It flashes when there is a request for more heat, but the heater is not on. Once set temperature is reached the heat indicator shuts off and the low speed of the jet pump turns off after 30 seconds (if not in filter cycle).
- Jets Operation: Firmly press the Jets button once to activate the low speed of the pump and again for the high speed. If left running the low or high speed pump will automatically turn off after 1 hour. The "Jets" indicator light next to the button will blink when jet pump is on low speed and is solid on high speed.
- Multi Colored LED Light: Press the Light button once to turn on the light, the light indicator next to the button is lit when the light is on. Press the button again to turn the light off. Quickly turn on/off the light to change the color. The sequence is as follows: White, Full color wheel, Amber, Blue, Red, Green, Purple, color wheel 1, color wheel 2 and abrupt color wheel. The last light mode used will come back on when the light is turned off for more than 2 seconds.